Silvia Club of NSW
http://forum.silviansw.com/

910 bluebird wagon
http://forum.silviansw.com/viewtopic.php?f=6&t=35398
Page 1 of 1

Author:  mistergTRx [ Thu May 30, 2013 5:57 pm ]
Post subject:  910 bluebird wagon

hi all,

where to begin?
current project is a 1984 910 bluebird wagon
H190 rear end (looking at the possibility of using an R31 diff in the future)
lowered front suspension
R31 swaybar up front
R31 calipers and rotors for the front
rear springs will be reset to lower it a little
twin swaybars at the back
inside is being fully rewired to allow me to use a s13 cluster (with head up display) while keeping to the old school analog dials
engine is a ca18de from a 1989 s13 silvia (had a full rebuild about four years ago and been sitting for three and a half years)
gearbox is a ca18 de auto (keeping it auto for a cruiser, plus im just plain lazy)

its been along time in the making for this project (engine was to be used in an older bluebird, but rust got the better of it)
but luckily it means i have pretty much sorted the main engine harness out, so far the biggest problem i have is with the ca18 auto box (nobody keeps anything for them) ive been searching for the harness that goes into the gearbox computer for a month now and no luck anywhere (maybe somebody on here has one they want to sell me?)

ive done all of the wiring myself, including the interior harness so i can add things like full electrics and relocate a few things

plan for this car in the long run is to use it as my daily, while still being able to take to the track

Page 1 of 1 All times are UTC + 10 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/