Silvia Club of NSW
https://forum.silviansw.com/

180sx heat problem
https://forum.silviansw.com/viewtopic.php?f=4&t=22135
Page 1 of 1

Author:  Willy [ Wed Apr 26, 2006 12:07 am ]
Post subject:  180sx heat problem

ive got an sr20det 180sx and when i first start the car say in the morning and let it warm up a bit then drive it, runs really good and after say if i keep driving for about half an hour 40 minutes straight and the engines warmer, when i accelerate hard at about 7-8psi it starts to just cut off and spluttrs and doesnt want go past about 4000 rpms and its even worse on high boost... ive had this problem for a while and ive done an oil change and it made it bit better used to do it jus drving it for 15 mins and it does that cutting off splurting thing.. dunno wat to do, just change the plugs to iridiums and didtn make a diffrence, got a walbro high flow pump... jus need help wit this if neone can thanks.......
also the turbo is right next to the igniter chip could that make a diffrence

Page 1 of 1 All times are UTC + 10 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/