THE INTAKE
First off what will be needed to get the piping from the front into the engine bay.
Parts used:
2 x 80mm 90 deg. PVC elbows
1 X 100mm to 80mm reducer
1 x Length of 80mm PVC
Using smaller diameter pipe & fittings will make the job easier but you want the CAI as big as possible.
THE AIR BOX (barrel).
Parts used:
1 x Empty Taubmans 4 litre paint tin
1 x Air pod (Will change to a open top pod when I get the time)
1 x Funnel
1 x Paint tin pourer
3 x Self tapping screws & large washers
You will need to cut the base out of the paint tin. The pod filter seats perfectly where the paint lid used to be.
Here it is put together.
Join the air box to the intake with 80mm flexable hose.
AIR BOX TO INTAKE MANIFOLD
no pictures but a rundown of what was used.
1 x Length of 65mm PVC
1 x 65mm 45 deg. PVC elbow
2 x 65mm PVC joiners
1 x 65mm Silicone joiner
Here's a full view of it in the engine bay.
it's covered it with heat insulation which that can be found at Clark Rubber.
there are some clips that were fitted to stop the top from coming off the air box.
The battery had to be moved and changed to a smaller one depending on the car.
