or you can get a single gauge mount pod on the apillar and put boost gauge in only
| Silvia Club of NSW https://forum.silviansw.com/ |
|
| GAUGES https://forum.silviansw.com/viewtopic.php?f=2&t=19104 |
Page 2 of 2 |
| Author: | kurupt [ Wed Nov 02, 2005 7:03 pm ] |
| Post subject: | |
Took fergos advice just purchased dashmount gauge mould, water temp , oil temp and oil pressure temp gekko pivot gauges got them all set up looks great.There electric gauges.Purchasing greedy a pillar gauge mould next week holds two gauges so ill install mechanical boost gauge and tacho both hks.Was looking at defi gauges today guy said id need to buy the controller to go with them.So i dont think ill get defi they looked great though. |
|
| Author: | Biggles [ Wed Nov 02, 2005 9:09 pm ] |
| Post subject: | |
can I see a photo of this dash mount gauge setup you got? also, where did you get the stuff from? |
|
| Author: | Arkhaeon [ Thu Nov 03, 2005 2:43 am ] |
| Post subject: | |
what the hell do you want an A-pillar tacho for? doesnt the one on your standard cluster work? |
|
| Author: | kurupt [ Thu Nov 03, 2005 8:30 pm ] |
| Post subject: | |
Yeah does work but the a pillar gauge mould holds two gauges naturally one will be boost so i gotta put something in the second. |
|
| Author: | kurupt [ Thu Nov 03, 2005 8:32 pm ] |
| Post subject: | |
Will post pick on saturday once its all installed.cheers guys. |
|
| Author: | BT [ Fri Nov 04, 2005 5:47 am ] |
| Post subject: | |
Boost and oil pressure are usually ideal for the A pillar. You might want to use something other than a tacho now because it'll be going in the pod - maybe exhaust temp? |
|
| Author: | kurupt [ Sat Nov 05, 2005 11:19 am ] |
| Post subject: | |
Yep sounds like a plan, ill look into it further. Cheers |
|
| Author: | whyte [ Sat Nov 05, 2005 12:25 pm ] |
| Post subject: | |
or you can get a single gauge mount pod on the apillar and put boost gauge in only
|
|
| Author: | JayS14 [ Sun Nov 13, 2005 7:30 pm ] |
| Post subject: | |
Where can I get a sandwich plate for under the oil filter to stick the oil temp and pressure sensor in too and do I need I for water temp or where do I put it. By the way there auto gauge gauge's I know there not the best but they where for free so hay. Thanks. |
|
| Author: | mokompri [ Sun Nov 13, 2005 9:09 pm ] |
| Post subject: | |
seven hills motorsport connections had them for ~$50, but you had to drill and tap them yourself with correct thread perfectrun.com.au, have the greddy remote oil kit for around $220 to your door, with 1/8pt thread i believe for oil temp and pressure on another note, what are peoples thoughts on running oil pressure at the sandwich plate, or running them where the stock oil pressure sensor/switch is ? |
|
| Page 2 of 2 | All times are UTC + 10 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|