Silvia Club of NSW
https://forum.silviansw.com/

replacing side guard indicators
https://forum.silviansw.com/viewtopic.php?f=15&t=32617		 Page 1 of 1
Author:  ~bb~ [ Fri Jan 30, 2009 2:07 pm ]
Post subject:  replacing side guard indicators
Just need to know how you pop em out :)
do I need to go into the depth of removing the wheel guard fender thingys, and popping it out from behind the guard? or (i really don't want to do this unless there is a trick to it) pop it out with a flathead screwdriver from the front.

thanks poodles!

- Bree
Author:  ZEi250t [ Fri Jan 30, 2009 2:33 pm ]
Post subject: 
i pulled the clip off from the inner splash guard and pop it out.

i didnt want to use a screwdriver, but im sure you can if you want to. i didnt wan to risk damaging my paintwork.
Author:  ~bb~ [ Fri Jan 30, 2009 2:37 pm ]
Post subject: 
ZEi250t wrote:
i pulled the clip off from the inner splash guard and pop it out.

i didnt want to use a screwdriver, but im sure you can if you want to. i didnt wan to risk damaging my paintwork.


Ah so its as easy as just pulling 1 clip out, not the whole darn thing off? and then pushing it out from the inside of the guard..

Exactly why I don't want to use a screwdriver..
Author:  ZEi250t [ Fri Jan 30, 2009 2:46 pm ]
Post subject: 
yeah one side of the indicator has a plastic 'clip' that holds it onto the guard. its not difficult. just squeeze the sides and one bit will pop out.
Author:  ~bb~ [ Fri Jan 30, 2009 2:49 pm ]
Post subject: 
Cheers Zei. I will let you know how it goes after work. :)
Author:  Timo [ Fri Jan 30, 2009 5:26 pm ]
Post subject: 
i popped mine out with a flat head.

just use a really slim one, and slip in some paper or magazine underneath the screw driver so it doesnt touch the paint.
Author:  ~bb~ [ Sat Jan 31, 2009 5:22 pm ]
Post subject: 
all done cheers guys :)
Page 1 of 1 All times are UTC + 10 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/