hes saying they are good
| Silvia Club of NSW https://forum.silviansw.com/ |
|
| Torque Wrench https://forum.silviansw.com/viewtopic.php?f=15&t=29460 |
Page 1 of 1 |
| Author: | mokompri [ Mon Dec 17, 2007 2:13 pm ] |
| Post subject: | Torque Wrench |
im after a torque wrench that is accurate around the ~10nm mark, anyone have recommendations ? |
|
| Author: | badhairdave [ Mon Dec 17, 2007 3:48 pm ] |
| Post subject: | |
you mean within 10Nm or down to 10Nm? If it's down to 10Nm then you can exclude any of the 1/2 inch drive ones straight away and start looking at 3/8 drive ones. |
|
| Author: | mokompri [ Mon Dec 17, 2007 6:35 pm ] |
| Post subject: | |
nah down to ~10nm any recommendations ? |
|
| Author: | 182Go [ Wed Dec 19, 2007 6:11 pm ] |
| Post subject: | |
I have been using a Warren & Brown tension wrench for years, they are not particularly cheap but they seem to be fairly accurate. |
|
| Author: | JayS14 [ Wed Dec 19, 2007 10:02 pm ] |
| Post subject: | |
Warren & Brown are the shit, i have one. If you want to go down to ~10nm maybe a 1/4 drive but i never bother with stuff that low as you usaully get it right. A 3/8 and 1/2 inch ones cover every thing i do. |
|
| Author: | 182Go [ Fri Dec 21, 2007 7:58 pm ] |
| Post subject: | |
JayS14 wrote: Warren & Brown are the shit, i have one.
Well your not supposed to use it as a hammer. |
|
| Author: | mokompri [ Fri Dec 21, 2007 9:02 pm ] |
| Post subject: | |
|
hes saying they are good
|
|
| Author: | 182Go [ Fri Dec 21, 2007 9:07 pm ] |
| Post subject: | |
sorry my bad didn't see the "the" in there I thought he was saying they were crap
|
|
| Author: | doofus [ Sun Dec 23, 2007 11:31 pm ] |
| Post subject: | |
where can you get the Warren & Brown torque wrench from? |
|
| Author: | rusty1 [ Mon Dec 24, 2007 6:08 pm ] |
| Post subject: | |
doofus wrote: where can you get the Warren & Brown torque wrench from?
http://www.justtools.com.au/category169_1.htm 
|
|
| Author: | 182Go [ Mon Dec 24, 2007 6:11 pm ] |
| Post subject: | |
doofus wrote: where can you get the Warren & Brown torque wrench from?
Any reputable tool store will sell them. You probably wont get them at Supercheap 
|
|
| Page 1 of 1 | All times are UTC + 10 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|