Silvia Club of NSW
https://forum.silviansw.com/

Turbosmart boost controller problems
https://forum.silviansw.com/viewtopic.php?f=12&t=539		 Page 1 of 1
Author:  RR_180 [ Sat May 18, 2002 5:14 pm ]
Post subject:  Turbosmart boost controller problems
I have just purchased and installed a dual stage turbosmart boost controller in my SR20 180sx. - i Have set the boost settings to the lowest possible but it is boosting to 18psi or more rather than the normal 9 psi. I have checked vacume lines etc.. all appear OK. Is there anything that would cause this to happen? There is a second line coming off the wastegate actuator line what does this do? should this be disconnected/blocked? - any help would be appretiated!!! :-?
Author:  GT25-S13 [ Sat May 18, 2002 8:12 pm ]
Post subject: 
maybe its on the wrong way (yes it happens)

?
Author:  FLY 200 [ Sun Jun 16, 2002 7:24 pm ]
Post subject: 
its sounds like its on the wrong way take it off and re-install it, and study those instructions.
Author:  J [ Mon Jun 17, 2002 1:04 am ]
Post subject: 
and if you're hitting 18psi you might wanna go easy and be careful till you get it fixed up. You could start doing some damage there if you're not careful!
Author:  RR_180 [ Tue Jun 18, 2002 2:20 pm ]
Post subject: 
thanks for help - i installed it correctly turned out that i needed to block off the factory boost controller - now working great :D
Page 1 of 1 All times are UTC + 10 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/