Silvia Club of NSW https://forum.silviansw.com/ |
|
S14 jdm to adm engine install, wiring harness differences https://forum.silviansw.com/viewtopic.php?f=12&t=34717 |
Page 1 of 1 |
Author: | Killabeez [ Thu Sep 23, 2010 8:48 am ] |
Post subject: | S14 jdm to adm engine install, wiring harness differences |
Hey, I have a halfcut from a JDM Series 1 S14 with ABS. I want to put this into my ADM S14 Series 1 but the shell already has an engine wiring harness, should I install the engine harness from the halfcut or can I use the ADM harness? Are there any differences between them? the part numbers are different but I assume this is because 1 is ADM and 1 isnt. The part numbers for them are: ADM: 24011 76f10 JDM: 24011 66f06 Any help would be appreciated as I want to get the motor in ASAP Cheers |
Author: | Magnet [ Fri Sep 24, 2010 8:57 pm ] |
Post subject: | |
You can maintain the adm loom with the jdm motor the only reason you'd swap is if your car doesn't have ABS and you want to put it in, I'm assuming you're not running stock ecu so it's not like you'd use the jdm ecu cause it has a bettter tune or something |
Page 1 of 1 | All times are UTC + 10 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |