Silvia Club of NSW

hey guys. just wondering if anyone has fitted type x side skirts to a stock 180. if so how hard was it and is it a straight forward install.

thanks in advance

like 4 bolts from memory

_________________

does it fit flush cause i dont want to use any sikaflex.

also on the bottom of the skirts there are a few tabs which look like the bolt in. would i need to drill holes for these?

No.

Without the bodykit, the typeX is identical to the older versions..

Older versions could get the factory "aero" skirts as an option - typeX just came with skirts by default.

There are no modifications necessary, and you hardly even need sicaflex (my skirts were put on using no screws at all, only the tabs in the door, and they sit perfectly)

- 2 tabs in the door,
- 3 tabs under the sill,
- 2 screws in the front wheel arch
- 2 screws in the rear wheel arch
- Small dot of silicone/double sided tape on the flaps near the door if necessary

Nothing custom required.

thanks god.

the 3 tabs underneath and the 2 in the door sil how do they connect. i had a look and there wasnt any holes or mounting points under the car for the 3 tabs.

once you get the skirts, itll be clear..

they have a bit of metal that bends around the seam, then a bolt tightens against it (not through it)

In the doors, the plastic runners hold the upper tabs in place.

i get you now.

thanks heaps for that god. the skirts i wanted sold but hopefully more will pop up.

thanks again for the info

hahahaha..............guess who bought the skirts? meeeeee

lucky bum

how r the fitment?