Silvia Club of NSW

Ok i put on a pod filter and want to what to do with the other hose that used to go into the factory airbox its about 25mm diameter do i need to block it up or try and plumb it back into the air filter if so i can do this when i make up a new stainless steel box with a cai

_________________
There is a very fine line between "hobby" and "mental illness."

are you talking about the hose that goes back to a thing (sometimes called a "gulp" valve) bolted on to the right hand side of the engine?

Ur talking about the EGR pipe that runs into the airbox. i was told it was for emissions.
all u need to do is follow the pipe to the EGR valve and take off the pipe and the vacuum line just above it.

(but u need to block up the vacuum line)

juurift

yes xla 8 thats is it
and thanks juurift will do that tommorow what side is it best to block the vaccum line

_________________
There is a very fine line between "hobby" and "mental illness."

block it off from where u disconnect it.......if that makes sense.....

yeah juurift pretty much covered it..

personally what i did was take out completely the EGR valve, along with the two hoses, one that goes back to the old airbox and the other that goes down to the back of the dump pipe, i blocked up from where the metal pipe starts, this bit will be removed when i get a new dump pipe anyway..

re the vacumm line, i just blocked it at the end that joins to the sensor thingo..

Do rb20's have this? As I've just put one in and I'm going to be installing a pod and was wondering if I'll have this trouble