Silvia Club of NSW
https://forum.silviansw.com/

Probably a dumb question about wastegate actuator arms..
https://forum.silviansw.com/viewtopic.php?f=1&t=33070
Page 1 of 1

Author:  CraZeeE [ Fri Apr 03, 2009 8:51 pm ]
Post subject:  Probably a dumb question about wastegate actuator arms..

but.... is there any issue rotating them through 180 degrees?

The 2560 I got has this step in the actuator arm, in this position it fouls the water fitting I have. Theres no reason I cant rotate just the arm through 180 degrees so the step goes the other way is there? Leaving the housing (seen on the right of the pic below) mounted where it is? Presumably within the housing its just a diaphragmand theres no issues rotating just the arm (and thus the diaphragm within the housing) relative to the housing , right?

Image

Pic illustrates my point, sorry if its a stupid question but Ive never looked at how the wastegate actuator works inside.

Cheers.



edit: yeah no worries apparently.

Page 1 of 1 All times are UTC + 10 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/