Silvia Club of NSW
https://forum.silviansw.com/

Identify this turbo from crap pics and lame info I give you
https://forum.silviansw.com/viewtopic.php?f=1&t=28452		 Page 1 of 1
Author:  Nebuchernezzer [ Fri Sep 14, 2007 2:44 am ]
Post subject:  Identify this turbo from crap pics and lame info I give you
This is the turbo on my 180sx, I have no idea what it is really.
Things I do know:
It's T2 flange.
It's made by IHI.
The info tag fell off it
It has a bolt on inlet and outlet snout like a Garrett.
I'm told the engine makes 330ps or so (not sure if that's flywheel are at the rears), the turbo appears to be T28 sized externally but I have no specs so that doesn't mean much.

And I have some shite pics of it:
Image
Image

Anyone have any info on IHI turbos?
I was hoping that the ones with bolt on snouts aren't so common so identifying a model would be easier :).

It could well be a PE1420, I've got to have a look at the wastegate, it seems to be a destinctive design.
Image
Image
Author:  whyte [ Sat Sep 15, 2007 12:53 am ]
Post subject: 
hard to tell from those pics,
i think best bet is to take it out & take proper pics.
Author:  Nebuchernezzer [ Sat Sep 15, 2007 2:32 am ]
Post subject: 
'sif I'd dot that.

It's not got the fancy PE wastegate can.
If anyone has any info on IHI turbos it would be nice, it seems it's hard info to come accross.
Author:  DumHed [ Sat Sep 15, 2007 2:48 am ]
Post subject: 
IHI turbos often seem to have the model number stamped on the rear compressor cover plate - under the comp wheel. Handy!
Author:  Nebuchernezzer [ Sat Sep 15, 2007 11:53 pm ]
Post subject: 
Super usefull!
I'll check the number if it blows and I have to replace it :).
Author:  omg [ Sun Sep 16, 2007 11:18 am ]
Post subject: 
Apexi turbos were IHI with garrett flanges weren't they?
Author:  DumHed [ Sun Sep 16, 2007 1:25 pm ]
Post subject: 
yeah, but they have Apexi cast into the compressor cover.
Author:  omg [ Sun Sep 16, 2007 10:19 pm ]
Post subject: 
Ah, that would be kinda obvious :)
Author:  CMY180 [ Sun Sep 16, 2007 10:31 pm ]
Post subject: 
omg wrote:
Ah, that would be kinda obvious :)


*poke*
Author:  Nebuchernezzer [ Sun Sep 16, 2007 11:50 pm ]
Post subject: 
Lol yeah i checked that, they have apexi on the inlet and exhaust side castings.
This is probably the IHI design that they used as the basis for the PE and Apexi designs before they modded em.
Page 1 of 1 All times are UTC + 10 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/