| Silvia Club of NSW https://forum.silviansw.com/ |
|
| T25G Rotating the Housing https://forum.silviansw.com/viewtopic.php?f=1&t=21174 |
Page 1 of 1 |
| Author: | conversionking [ Thu Mar 02, 2006 2:55 pm ] |
| Post subject: | T25G Rotating the Housing |
Putting a T25G on a Ca18DET, i here you have to remove the circlip and then rotate it about 1cm? Is this the circlip on the actuator arm or another one? How does this rotation effect the actuator arm and will it still perform normally? Is there anything else that needs to be done to fit it on the stock exhaust housing? Thanks! |
|
| Author: | DumHed [ Thu Mar 02, 2006 4:01 pm ] |
| Post subject: | |
it's the circlip on the compressor housing. The wastegate actuator will be at a slightly different angle afterwards, but it should still work fine. |
|
| Page 1 of 1 | All times are UTC + 10 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|